HDi Ford PX Ranger/Mazda Bt50 GT2 intercooler kit Hdi

HDi Ford Ranger intercooler /Mazda Bt50 GT2 complete intercooler kit is
HDi high efficient GT2 core 670mm X 260mm X 70 mm designed to replace a regular standard factory unit and give greater airflow potential resulting in increased performance and reduce in mileage.
Installation:
Installation of HDi Ford Ranger/Mazda Bt50 GT2 complete intercooler kit is simple. It is easily installed with basic workshop tools, installation is a quick and easy process normally it takes less than 40 min

Performance guaranteed!:
After hundreds of hours in design and testing, Dyno test has proven to improve 6hp-15hp horse power and 10nm-20nm of torque throughout the rpm range! The HDi Ford Ranger/Mazda Bt50 GT2 benefit as below:
? Improved low end throttle response (refer dyno)
? Minimal pressure drop despite large intercooler sizing (thanks to HDi GT2 technology)
? Increased torque range at low end (refer dyno)
? Reduction of both inlet temperatures
? less engine running temperatures
? Increased performance
? Better reliability and consistency
? Increase power throughout entire RPM range (not only focusing on the PEAK)
? Improve fuel efficiency*
? Best value for money
? Performance guaranteed!

The kit comes with HDi reinforced Silicon hose to replace the standard Rubber hose which prompt to expand and split.
Full stainless steel screws and brackets the best durability against water and salt corrosion.
The special design allowing enough area for aftermarket 4wd winch to be installed
It also allows good air flow to the radiator!
*The reduced inlet restriction and inlet temperature provides higher density of oxygen for better combustion with the same amount of fuel. Hence, increase mileage!